Відео

They just got all their teeth and they bite each other

Thanks for watching!

What are you cutting?

If you're in contact, the wire is touching the part, maybe a slug that has dropped. If it's contacting while it's cutting maybe try slowing feed down and make sure it has adequate flushing. Flushing is most important thing probably.

As far as I know, you have to do it one file at a time.

Bir adet mv2400 r makinem var. Z57 TCC warring 0010 diye bı alarm alıyorum bunun sebebi nedir.

You wouldn't be the pilot of this particular airplane would you?

@@emmvee1678 No but mine was just like it.

600 hp wow!

Ikr

They all sold!

Thanks for watching.

ua-cam.com/video/aZJLvByys7g/v-deo.html (go to 5:30 mark of part one video)

Western ny

What are you wiring? With Aluminum, you can let them dry out and drop them on the floor to shake the material off. Then they can go a bit longer.

There are also companies that make filter baskets where you can change out the filter. Hoff engineering company is one I've used in the past and that can be cheaper alternative.

@@emmvee1678 thanks for the suggestion. I've saved my old filters as they seemed very light. I will shake them and even hook a vacuum to the port. I cut a lot of brass and copper and also tool steel. At least I have a few things to try

@@danneumann3274 I don't know how much more you'll get out of them having wired those materials. They're probably spent but it's worth a try. Just hold them at chest height, right side up, and drop them a couple times to shake the material off inside.

Thanks so much. It sure seems like the used to last longer. Thanks also for the great video. I use it for training

As it says in the description my dear.

Ahhh reading, my life long enemy

Actually I have two of these lawn mowers. Purchased a second one after this video was shot. This one has an oil filter and the other one doesn't have one.

I just change the oil twice as much without filter. Like halfway through mowing season change it again.

Make sure you check the oil the right way too. Dipstick just sits on top of tube to check it, don't screw it in.

Thank you just making sure I wasn’t going crazy

No problem. I was amazed that it didn't have one. When the other one I have did. Same engine.

What machine do you have? Have you crashed the machine? Maintain at device is just the machine telling you what sensor the wire got to and it has a limit.

At maintain you can go to maintenance and at maintain, and clear each one. It's not significant.

S01 server alarm, hmmm, try shutting the machine down completely and turning it back on.

@@emmvee1678 Thanks. Iw ill try that

@@emmvee1678 Its MV2400

Fx10s and fx20 I've seen are totally whopped, but still accurate.

@@emmvee1678 they cut 1/2 as fast and use twice the wire as the mv1200. Still cuts good though.

Yeah man, I started on mv4800, then mv2400, and moved to shop with fxs and old fas. Mv threads way better too.

@@danneumann3274 if youre using power Master that uses a lot more wire.

@@emmvee1678 on the fx or the mv?

Did you crash it?

Yes. Sorry for the delay. I think his name is Trent langelier.

@@emmvee1678 I thought so. He was the tech I had a few years back.

The way I learned was to watch this video every time and I eventually learned.

It is better than an old fx that will not come apart also.

Hi how to settings store program mitsubishi machine

I work at an aerospace place, it's hard to get away with using a camera without getting fired. Let me know what you need and I'll try to answer with a video.